Chrysler Service Brakes, Air Supply Hoses, Lines/piping, And Fittings


View 2 Service Brakes, Air Supply Hoses, Lines/piping, And Fittings Safety Reports

Chrysler New Yorker 1990
Daimlerchrysler Corporation
Safety incident date:
Jan 08, 2001
Location:
West Bloomfield, MI

high pressure rubber hoses to the front two wheels become frayed and break at a metal clamp that holds the hoses in place in the wheel wells. this happened to both front brakes. the clamp is located on the strut and should be eliminated or the hose made longer. loss of brakes occurs when hose breaks

0 person(s) were injured. 0 person(s) died.Vehicle Identification Number (VIN):1C3XY66R7LD. Vehicle was purchased on Nov 01, 1994. Vehicle was not using anit-lock brakes. Vehicle was using Cruise Control.Chrysler NEW YORKER 1990 Drive type:FWD. Fuel System:N/A. Fuel type: gas. Vehicle Speed: 30 mph.

Chrysler 300m 2000
Chrysler Group Llc
Safety incident date:
May 21, 2002
Location:
Rising Sun, MD

on monday, 5/20, i was exiting my 2000 chrysler 300m and as i pulled the interior driver's side door handle, the chrome plating on the handle split along the top seam, slicing a deep gash in my middle finger. after attending to the wound, i found that the center of the door handle now has a 2" section of the chrome finish that has torn away from the handle, leaving a horizontal, razor-sharp protrusion that could cut me again at anytime. fearing this hazard would cause further injury to me or members of my family, i contacted my dealer, brandywine chrysler jeep in wilmington, de about getting a replacement handle for the driver's door. the parts department told me that chrysler doesn't make replacement door handles; i would need to order a whole new interior door panel at a cost of $309, not to mention the $70/hour labor to install it. i went to their service department yesterday, 5/21, and the service guy remembered having a door panel in the shop and went to see if there's something he could do. he returned to tell me that there's no way to remove the handle from the panel without damaging it, and told me that the only option is to replace the door panel because the protruding strip of chrome finish cannot be repaired. even if it were possible to remove the treacherous 2" section of finish from the handle, that would leave two equally sharp and dangerous vertical edges running completely around the handle. today i contacted chrysler customer service via email about the defect, and they sent me a cursory response that said theres nothing they can do since the handle is part of the door assembly. they didnt even mention the injury or defective handle.*ak

1 person(s) were injured. 0 person(s) died.Vehicle Identification Number (VIN):2C3HE66G8YH. Original Owner. Vehicle was purchased on July 01, 2000. Vehicle was using anit-lock brakes.Vehicle was using Cruise Control.Chrysler 300M 2000 Drive type:FWD. Fuel type: gas. Vehicle Speed: 0 mph.


Common Chrysler Problems

View Service Brakes, Air Supply Hoses, Lines/piping, And Fittings Safety Reports

Electrical System (2733 Reviews)

Power Train:automatic Transmission (1600 Reviews)

Engine (1314 Reviews)

Engine And Engine Cooling (1217 Reviews)

Air Bags (1181 Reviews)

Engine And Engine Cooling:engine (1144 Reviews)

Steering (1101 Reviews)

Power Train (1019 Reviews)

Service Brakes, Hydraulic:antilock (1011 Reviews)

Vehicle Speed Control (958 Reviews)

Fuel System, Gasoline (799 Reviews)

Air Bags:frontal (712 Reviews)

Service Brakes, Hydraulic (704 Reviews)

Suspension (665 Reviews)

Structure (620 Reviews)

Exterior Lighting (571 Reviews)

Unknown Or Other (515 Reviews)

Engine And Engine Cooling:engine:gasoline (477 Reviews)

Fuel/propulsion System (459 Reviews)

Structure:body (438 Reviews)


footer